Wilbur-curtis SLG User Manual download pdf

ADJUSTING THE GRINDS

Refer to illustration, page 2. This adjustment may change the amount of ground coffee dispensed.

1. Empty hopper of coffee beans. Run grinder to clear grinding burrs of coffee.

2. Open housing cover to locate adjustment screw (8) and lock nut (7). Loosen lock

nut.

3. Run motor during adjustment. Turning adjustment screw clockwise will result in a

ner grind (if, while turning, you hear the grinding burrs starting to touch, immedi-

ately, back off 1/8th turn). Turning counter clockwise will produce a coarser grind.

4. With a screwdriver holding the adjustment screw in place, tighten the locknut.

5. Run some coffee beans through the machine to check the grind adjustment.

6. Replace front cover on machine.

CHANGING A BROKEN SHEAR DISK

1. Unplug the power cord.

2. Open the hopper and remove any coffee beans, then open the front cover.

3. On the grind motor assembly, take out the two thumb screws (10) and remove the grind cap (6).

4. Pull out the grinding burr/feed worm assembly (2). The inner half of grinding burrs will remain within the housing.

5. Separate the shear cap (5) and shear drive (3). The broken shear disk (4) should fall out from the slot on the drive.

6. Inspect and clean the housing (1) of any coffee or debris. Especially, look for something that could have caused the

shear disk to break.

Fi n d o u t m o r e

o n t h e w e b .

WILBURCURTIS.COM

Important Safeguards/Conventions

CAUTION: Please use

this setup procedure

before attempting to

use this grinder. Failure to follow

the instructions can result in injury

or the voiding of the warranty.

WARNING TO AVOID

SCALDING, Do not

remove brewcone while

brew light is ashing.

ISO 9001 REGISTERED

Service Manual – Low Prole Grinder

For the Latest speciFications and inFormation go to www.wiLburcurtis.com

This appliance is designed for commercial use. Any servicing other than cleaning and maintenance should be performed

by an authorized Wilbur Curtis service center.

• Do NOT immerse the unit in water or any other liquid

• To reduce the risk of re or electric shock, do NOT open top panel. No user serviceable parts inside. Repair should

be done only by authorized service personnel.

• Keep hands and other items away from hot parts of unit during operation.

• Never clean with scouring powders or harsh implements.

Conventions

WARNINGS – To help avoid personal injury Important Notes/Cautions – from the factory

QUICK START & SETUP - SLG

1. Install the grinder on a rm, level counter top in a location where it can be connected to a grounded electrical outlet of

120VAC, rated at 15 amps.

2. Test the unit by running some whole bean coffee through the grinder. If any problems are encountered, refer to the

troubleshooting section complete at www.wilburcurtis.com or call Technical Support at 800-995-0417.

OPERATING INSTRUCTIONS - SLG

The SLG grinder is adjusted at the factory to grind 2 - 2.5 ounces of medium roast coffee.

1. Lift off the clear hopper lid and ll the hopper with whole coffee beans.

2. Place a new lter into your brew cone. Slide the brew cone into the brew cone rails on the grinder.

3. Push the START switch on the front panel. The SLG will start to grind coffee into the brew cone.

4. Wait for the grinder motor to stop before removing the brew cone.

Wi l b u r Cu r t i s Co m p a n y , in C .

Models Included

SLG

WILBUR CURTIS COMPANY

Montebello, CA 90640

1 2 3 4 5 6

Summary of Contents

Page 1 - t h e w e b

ADJUSTING THE GRINDSRefer to illustration, page 2. This adjustment may change the amount of ground coffee dispensed.1. Empty hopper of coffee beans.

Page 2 - GRINDER MOTOR

2NOTE: Time settings in this table are only ap-proximate. Amounts will vary with grind texture and specic coffee bean. Weigh your output, then make a

Page 3 - DIAGRAMS

3PARTS DIAGRAMS32158674910WC-9178WC-9169WC- 628WC-1504WC-3502WC-6550WC-9135WC-38027WC-38339WC- 101 1 2 3 4 5 6 7 8 910HOPPER COVER, CLEAR P

Page 4 - SCHEMATIC

ELECTRICAL SCHEMATIC4

Page 5 - SLG GRINDER

ROUGH-IN DRAWING SLG GRINDER

Page 6 - Product Warranty Information

3/5/8 . 9.9 . ECN 938210/16/01 . 10.6 . edr 3167 Rev NCPrinted in U.S.A. 3/09 F-3217-S Rev AWILBUR CURTIS CO., INC.6913 Acco St., Montebello, C

Comments to this Manuals

No comments

Wilbur-curtis SLG User Manual

Browse online or download User Manual for Coffee machines Wilbur-curtis SLG. Wilbur Curtis SLG User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Coffee machines Wilbur-curtis SLG